GroIMP wiki

a part of grogra.de

User Tools

Site Tools

Trace:
tutorials:spectral-light-modeling-architecture

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
tutorials:spectral-light-modeling-architecture [2025/05/28 23:58] – barley1965tutorials:spectral-light-modeling-architecture [2025/06/01 17:45] (current) – barley1965
Line 136: Line 136:
 </code> </code>
  
-//Tasks: +Tasks: 
 1) Run the model with different lamp configurations! Observe the effect on internode length and leaf surface dynamics! 1) Run the model with different lamp configurations! Observe the effect on internode length and leaf surface dynamics!
  
 2) Run the model for a number of steps, then move a lamp<sup>*</sup>, or change its power output! You can also add a Sky light source but beware that this has a dramatic effect on the R/FR ratio (hint! To prevent this, you have to increase the power output of the two far red lamps as it currently is too low). Once you have added a Sky light, you can also have a look at the Photosynthesis rate dynamics (for some reason, the light output of the LED lamps alone is a bit too low).  2) Run the model for a number of steps, then move a lamp<sup>*</sup>, or change its power output! You can also add a Sky light source but beware that this has a dramatic effect on the R/FR ratio (hint! To prevent this, you have to increase the power output of the two far red lamps as it currently is too low). Once you have added a Sky light, you can also have a look at the Photosynthesis rate dynamics (for some reason, the light output of the LED lamps alone is a bit too low). 
  
-3) Open the Excel file Spectre.xlsx and inspect the way the relation between absorbed blue and rfr and slope/maximum dimension has been implemented! +3) Open the Excel file {{tutorials:spectre.xlsx|Spectre.xlsx}} and inspect the way the relation between absorbed blue and rfr and slope/maximum dimension has been implemented! 
  
-4) Currently we have only one plant in the scene: go to Parameters.rgg, L. 45, 46 and 49 and modify the parameters so that you get 25 plants (5 x 5), with plant number 13 being the chosen one! Then run the model again to see if the plants will develop differently!}}// +4) Currently we have only one plant in the scene: go to Parameters.rgg, L. 45, 46 and 49 and modify the parameters so that you get 25 plants (5 x 5), with plant number 13 being the chosen one! Then run the model again to see if the plants will develop differently! 
  
 ''<sup>*</sup>To move a lamp, you can click on its tip and then drag the lamp into one direction (x, y z) by clicking, holding and moving one of the three arrowheads. If selection in the scene doesn’t work you can try finding the lamp using the Flat Object Inspector window that is already open in your model:''  ''<sup>*</sup>To move a lamp, you can click on its tip and then drag the lamp into one direction (x, y z) by clicking, holding and moving one of the three arrowheads. If selection in the scene doesn’t work you can try finding the lamp using the Flat Object Inspector window that is already open in your model:'' 
      
  
tutorials/spectral-light-modeling-architecture.1748469482.txt.gz · Last modified: 2025/05/28 23:58 by barley1965